What Are Shield and Wave Washers?
Shield and Wave Washers are small but essential parts used in SRAM bottom bracket assemblies. They help protect bearings, take up space, and ensure proper alignment between the crank and frame. Depending on your bottom bracket system, you may need a specific kit or individual washer.
Available Configurations
- Shield and Wave Washer: These SRAM Shield and Wave Washers are available in several configurations to suit different bottom bracket systems and crank setups. Options include kits and individual washers for Truvativ BB30, PressFit 30, PressFit GXP MTB, and GXP Specialized 84.5 bottom brackets. Choosing the correct configuration ensures a proper fit and avoids compatibility issues during installation.

Shield and Wave Washer - Shield and Wave Washer: Also includes a wave washer for a GXP crank to PressFit bottom bracket adaptor (24.5mm), sold in a quantity of 5. This specific wave washer is designed for a particular adaptor setup, so you need to verify your crank and bottom bracket type before purchasing.
How to Select the Right Washer
- Identify Your Bottom Bracket System: Check your bike's bottom bracket standard: BB30, PressFit 30, PressFit GXP MTB, or GXP Specialized 84.5. This determines which Shield and Wave Washer kit or individual washer you need.
- Check Your Crank Setup: If you are using a GXP crank with a PressFit bottom bracket adaptor, you will need the wave washer specifically made for that adaptor (24.5mm). This is sold separately in a pack of 5.
- Use the Options Selector: Each configuration is listed under the product's Options selector. Choose the one that matches your bottom bracket and crank combination.
Installation Tips
- Clean the Area: Before installing, clean the bottom bracket shell and bearing surfaces to remove any dirt or old grease. This helps the washers sit flat and function correctly.
- Position the Washers Correctly: Place the shield washer against the bearing to protect it from debris, and the wave washer between the crank and bottom bracket to take up any axial play. Ensure they are oriented as shown in your bottom bracket's manual.
- Tighten to Manufacturer Specifications: Torque the crank and bottom bracket components to the values specified by SRAM or the frame manufacturer. Over-tightening can damage the washers or bearings.
What the Catalog Confirms
The Shield and Wave Washers are designed as replacement or setup components for compatible SRAM bottom bracket systems. The catalog confirms the available configurations and the specific 24.5mm wave washer for GXP crank to PressFit adaptors. However, it does not provide detailed installation torque values or step-by-step instructions for every bottom bracket type. Always refer to your bottom bracket's official manual for precise torque specs and assembly order.


